Sofirn SP31 V2.0 Powerful Tactical LED Flashlight 18650 Cree XPL HI 1200lm Torch Light Lamp with Dual Switch Power Indicator ATR
Cree XPL-HI V3 LED
Voltage: 2.8-6.6 volts
Battery Supported: single 18650 or 2*CR123A li-ion batteries
Dimension: 133.5mm(length)* 23.4mm(head)
Net Weight: 72±1 gram (no batteries included)
Made by Aircraft 6061 grade-aluminum alloy, Premium type Ⅲ hard-anodized anti-abrasive finish to get solid built body, anti-crash.
Toughened glass lens with purple AR coating; Smooth Reflector
Mode Memory: It memorizes the last brightness level used in the general modes, but it does not remember the Strobe mode. It will activate the last brightness you selected, when you turn on the flashlight next time.
Reverse polarity protection: to protect from improper battery installation
Constant current output is adopted
Advanced temperature regulation (ATR) technology：
It adjusts the brightness level automatically when the driver temperature reaches 60℃ to keep the light from overheat.
Turbo steps down to High after working for 3 minutes to avoid overheat. The ART works if the drivers reaches 60℃.
Low voltage warning:
It is lower than 3.1 volts if the LED Red indicator (on the side switch) flashes rapidly when you turn on. Then please recharge the battery.
Low Voltage Protection:
If the voltage is lower than 3.0 volt when turn on, automatic stepdown works. so it keeps stepping down to the lowest mode and runs out power juice. Please insert new battery if you get this signal.
Battery Capacity Indicator (LED on the side switch)
The indicator is on for 5 seconds every time when light turns on. It shows green or red to indicate the battery power.
Steady Green: enough power
Steady Red: short of power
Flashing Red: running out of power. Please insert a new battery!
The tactical tail switch turns on or off
The side switch to choose modes
1.one click to adjust one mode. It cycles from Eco-- Low --Medium--High --Turbo --Eco;
2.Press 1.2 seconds to active Strobe, and one click again to active SOS; it cycles SOS-- Strobe-- SOS; press 1.2 seconds again to returns to common modes
3.Memory function: It work for Eco/ Low / Medium / High/ Turbo (Strobe or SOS cannot be memorized)